If you're remodeling your commercial building but have no idea how to install drywall, you've come to the perfect place. Drywall is made of mineral gypsum and is a considerably large, heavy, and unwieldy building material. Even though you can install drywall yourself, the job will be much easier if you have a helper or assistant. A degree in construction is not required to complete this project flawlessly. But what you do need are some hanging drywall tips and tricks to achieve your desired output.
Tip #1 Prepare the Necessary Tools
Before starting your project, you might want to check and prepare the necessary tools and materials to prevent issues. It's better to be prepared than to watch yourself drive back and forth to the hardware store to buy the equipment you need. You can include your drywall access doors and panels on the list if you want to add a more safe and aesthetic way to hide your electrical wirings and plumbing.
Tip #2 Measure and Cut Drywall
To achieve more accurate placement of your drywall, make sure to measure out from a corner, perpendicular to the strapping, or the joists to determine where the first panel's end will land. If the board doesn't occupy the entire ceiling or wall, its end must touch the middle of a strapping piece or joist. Mark that measurement on the edge of the first panel—Mark the tip of the plate at all locations where strapping or joists intersect the wall. Marking is essential, especially if you're figuring out where screws will go around the room or in cutting your drywall.
Tip #3 Check the Wall Studs
To achieve a more flawless wall, always check the studs and joists for bows or twists. The finished walls will look much better if the studs are as flat as possible. Inspect the studs to see if they are aligned perfectly. To confirm alignment, hold a long, straight board across the framing. Trim with a saw or a power planer if any framing members stick out(especially for a large installation). Lastly, fill in low spots with shims attached with nails or glue.
Tip #4 Driving in Screws and Nails
Screws must be driven below the surface of the drywall and covered with joint compound. Remember not to drive them in so deep because this will tear the paper surface and damage the gypsum core. On the other hand, hammering drywall nails can be a more forgiving technique than driving drywall screws. Drywall screws tend to penetrate the drywall paper and tear through instantly rapidly. But with hammering, the broad head of the hammer allows for several blows before the paper tears.
Tip #5 Placing your Drywall into Place
If you plan to cover both your ceiling and wall with drywall, always start with the top. When attaching drywall to the ceiling, joists should be spaced 16 inches on center; space fasteners 12 inches apart. While with wall studs, the maximum spacing between fasteners should be 16 inches. Always remember to start with the top and work your way down. The key is to make your cut side facing the floor, to be covered by baseboards.
Become an expert in remodeling your place of business or your home. Check out our website for more excellent quality access doors and panels to choose from.https://www.bestaccessdoors.com/ or contact us at 1-800-483-0823
Comments